OBJECTIVES

(A). Dis-assembly & Assembly Practices
i. Tools and its handling techniques.
ii. Dis-assembly and assembly of home appliances – Grinder Mixer Grinder, Ceiling Fan, Table Fan & Washing Machine.
iii. Dis-assembly and assembly of Air-Conditioners & Refrigerators.
iv. Dis-assembly and assembly of a Bicycle.

(B). Welding Practices
i. Welding Procedure, Selection & Safety Measures.
ii. Power source of Arc Welding – Gas Metal Arc Welding & Gas Tungsten Arc Welding processes.
iii. Hands-on session of preparing base material & Joint groove for welding.
iv. Hands-on session of MAW, GMAW, GTAW, on Carbon Steel & Stainless Stell plates / pipes, for fabrication of a simple part.

(C). Electrical Wiring Practices
i. Electrical Installation tools, equipment & safety measures.
ii. Hands-on session of basic electrical connections for Fuses, Miniature Circuit Breakers and Distribution Box.
iii. Hands-on session of electrical connections for Lightings, Fans, Calling Bells.
iv. Hands-on session of electrical connections for Motors & Uninterruptible Power Supply.

(D). Electronics Components / Equipment Practices
i. Electronic components, equipment & safety measures.
ii. Dis-assembly and assembly of Computers.
iii. Hands-on session of Soldering Practices in a Printed Circuit Board.
iv. Hands-on session of Bridge Rectifier, Op-Amp and Transimpedance amplifier.
v. Hands-on session of integration of sensors and actuators with a Microcontroller.
vi. Demonstration of Programmable Logic Control Circuit.

(E). Contemporary Systems
i. Demonstration of Solid Modelling of components.
ii. Demonstration of Assembly Modelling of components.
iii. Fabrication of simple components / parts using 3D Printers.
iv. Demonstration of cutting of wood / metal in different complex shapes using Laser Cutting Machine